Model A Distributor Assembly

Distributor Housing Body - 1928 to 1931 No Exchange Required.

Bushing - Distributor Shaft. 1928 to 1934 4 Cylinder. each

Oiler - Distributor Shaft. 1928 to 1934 4 Cylinder

Fiber Washer - Distributor Shaft Sleeve 1928 to 1934

Distributor Shaft Sleeve & Pin 1928 to 1934 4 Cylinder.

Distributor Shaft Pin 1928-1934

Distributor Cap Clamp & Rivet Set 1928 to 1934 4 Cylinder.

Rivets - Distributor Clamp 1928 to 1934

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Lower Plate - Distributor 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Spring - Distributor between upper & Lower Plates. 1928 to 1931

Modern Upper Distributor Plate Complete with Modern Points & Condenser. 1928 to 1931

The reproduction points that have been made since around 2017 are unfortunately made wrong and the manufacturer refuses to correct the problem. The issue is that the distance from the pivot point to the contact is longer than it should be. This is supposed to be 1.210" center to center. The current reproduction points are about 1.248." This point block has been modified in how it mounts to the upper plate to compensate for the length difference and give you a proper alignment of the contacts. Made in U.S.A.

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Distributor Upper Shaft with Oil Hole 1928-1931

Cam - Distributor with 'B' Profile. 1928 to 1934 4 Cylinder These cams are made from aircraft strength 1144 steel, with a Rockwell hardness of 23. They have been precision ground to be within .0005” to meet Ford’s original specifications. Polished to a mirror smooth surface with the “B” profile which creates a hotter spark. Made in USA

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Hardware Kit - Distributor Screw & Washer Set. 1928 to 1931

Distributor Body with Electrodes. 1928-1934 USA Made

Rotor - 4 Cylinder Distributor. 1928 to 1934 The correct rotor gap on a Ford Model A should be between 0.025 to 0.030 inches

Cap - Distributor. 1928 to 1934 USA Made